Removal and Installation

REAR DOOR GLASS AND REGULATOR

Removal and Installation












DOOR GLASS

Removal
1.Remove the rear door finisher. Service and Repair.
2.Disconnect the harness connector of rear door speaker.
3.Position aside the vapor barrier.
NOTE:
If the vapor barrier is reused, cut the butyl-tape so that a part of the butyl-tape remains on the vapor barrier.





4.Remove partition sash bolt and screw, pull the partition sash downward and tilt the upper end of the sash forward to pull out the sash upward.





5.Pull out the partition glass in the direction as shown.





6.Temporarily reconnect the power window switch to operate the windows.
7.Raise or lower until lower glass bolts can be seen.
8.Remove the rear door glass bolts.
9.Pull out the rear door glass toward the outside of the door to remove.
10.Remove the door glass run from the door panel.
Installation
Installation is in the reverse order of removal.

REGULATOR ASSEMBLY

Removal
1.Remove and position aside the rear door finisher. Service and Repair.
2.Disconnect the harness connector of rear speaker.
3.Position aside the vapor barrier.





4.Temporarily reconnect the power window switch to operate the windows.
5.Raise or lower until lower glass bolts can be seen.
6.Remove the rear door glass bolts.





7.Raise up the door glass and hold with a suction lifter A.





8.Remove the regulator bolts, and then remove the regulator assembly from the door panel.
Installation
Installation is in the reverse order of removal.
Inspection after Removal





Check the regulator assembly for the following. [If a problem is detected, grease or replace it as shown].
- Gear wear
- Regulator deformation
- Grease condition for each sliding part