Alarm System Transponder: Service and Repair

NATS ANTENNA AMP.

Removal and Installation

NOTE:
- If NATS antenna amp. is not installed correctly, NVIS (NATS) system will not operate properly and "SELFDIAG RESULTS" on CONSULT screen will show "LOCK MODE" or "CHAIN OF IMMU-KEY".
- Initialization is not necessary when only the NATS antenna amp. is replaced with a new one.

REMOVAL

1.Disconnect the battery negative terminal. Removal and Replacement.
2.Remove the instrument lower panel LH. Instrument Lower Panel LH.





3.Remove the NATS antenna amp bolt (A).
4.Disconnect the electrical connector (1) and remove the NATS
antenna amp (2).

INSTALLATION

Installation is in the reverse order of removal.