Removal And Installation

FRONT DOOR LOCK

DOOR LOCK : Removal and Installation


REMOVAL

1.Remove inside handle. Service and Repair.
2.Remove outside handle. Service and Repair.
3.Disconnect door lock actuator harness connector (if equipped).
4.Remove front door lower sash (rear). .
5.Remove door lock assembly TORX bolts and door lock assembly.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
- Do not reuse TORX bolt. Always replace it with a new one when it is removed.
- Check door open/close, lock/unlock operation after installation.
- Check door lock cable is properly engaged with outside handle bracket.





- Check door lock assembly for poor lubrication. Apply body grease to door lock if necessary.