Removal And Installation

REAR DOOR LOCK

DOOR LOCK : Removal and Installation


REMOVAL

1.Remove inside handle. Service and Repair.
2.Remove outside handle. Service and Repair.





3.Remove bolt (A) from the partition sash (1).
4.Disconnect door lock actuator harness connector (if equipped).
5.Remove door lock assembly TORX bolts and door lock assembly

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
- Do not reuse TORX bolt. Always replace it with a new one when it is removed.
- Check door open/close, lock/unlock operation after installation.
- Check door lock cable is properly engaged with outside handle bracket.





- Check door lock assembly for poor lubrication. Apply body grease to door lock if necessary.