Magnetic Clutch

MAGNET CLUTCH

Description


SYSTEM DESCRIPTION

When the blower speed dial is in one of the fan speed positions, the front air control outputs a fan ON signal to the BCM. When the A/C switch is pressed, the A/C switch LED illuminates and the front air control outputs a compressor ON signal to the BCM. Any mode control button can be selected. As long as the BCM receives a compressor ON signal and a fan ON signal from the front air control, the conditions required for the BCM to transmit a compressor ON request to the ECM have been met.
The BCM sends a compressor ON signal to ECM, via CAN communication line.
The ECM judges whether the compressor can be turned ON, based on each sensor status (refrigerant pressure sensor signal, throttle angle sensor, etc.). If it judges the compressor can be turned ON, it sends a compressor ON signal to IPDM E/R, via CAN communication line.
Upon receipt of a compressor ON signal from ECM, IPDM E/R turns the A/C relay ON to operate the compressor.


Component Function Check


1. CHECK MAGNET CLUTCH OPERATION

Perform auto active test of IPDM E/R. CONSULT Function (IPDM E/R).
Is the inspection result normal?
YES- Inspection End.
NO- .


Diagnosis Procedure

Regarding Wiring Diagram information, Manual Air Conditioning System.

1. CHECK FUSE

Check 10A fuse (No. 42, located in IPDM E/R).
NOTE:
IPDM E/R Terminal Arrangement.
Is the inspection result normal?
YES- GO TO 2.
NO- Replace the blown fuse after repairing the affected circuit.

2. CHECK MAGNET CLUTCH

1.Turn ignition switch OFF.
2.Disconnect compressor connector.
3.Directly apply battery voltage to the magnet clutch. Check for operation visually and by sound.
Does it operate normally?
YES- GO TO 3.
NO- Replace magnet clutch. Removal And Installation.

3. CHECK MAGNET CLUTCH POWER SUPPLY CIRCUIT FOR OPEN

1.Disconnect IPDM E/R connector.
2.Check continuity between IPDM E/R harness connector and compressor harness connector.





Is the inspection result normal?
YES- Replace IPDM E/R. Service and Repair.
NO- Repair harness or connector.