Removal And Installation

REAR COMBINATION LAMP

Removal and Installation


CAUTION:
- Wrap the tip of remover tool with a cloth to protect the body from damage.

REMOVAL

1.Remove trunk rear finisher. Refer to. Trunk Rear Plate.
2.Remove rear combination lamp nuts.





3.Disengage the locating pin (A) of the rear combination lamp using tool (B) at the gap between the rear combination lamp and rear fender.

CAUTION:
Apply protective tape (C) on body to protect the painted surface from damage.
4.Disconnect rear combination lamp connector, and then remove rear combination lamp.

INSTALLATION

Installation is in the reverse order of removal.