Operation CHARM: Car repair manuals for everyone.

Maintenance Indicator Reset






SERVICE INTERVAL REMINDER (if so equipped)

When the ignition switch is placed in the ON
position, a wrench symbol and the distance to oil
change information will illuminate on the display
for approximately 5 seconds. The wrench symbol
and distance to oil change switch to oil display
status. Then the oil display status switches to
odometer and twin trip odometer/trip computer
information mode that was displayed before the
ignition switch was placed in the ACC, OFF or
LOCK position.

The oil level display status provides specific information
regarding your approximate engine oil
level.

If the oil level is sufficient, Oil Good is displayed
for approximately 10 seconds. If the oil level is
low, Oil Lo blinks for approximately 30 seconds
in order to draw your attention to necessary action.






Quickly push and release the trip computer
change button A on the instrument panel located
near the speedometer B during the Oil
Good or Oil Lo mode to display an approximate
oil level indication.
he proper engine oil refilling procedure.

Oil change schedule set up

It is possible to adjust the interval distance to oil
change by pushing the trip computer change
button A on the instrument panel located near
the speedometer B for 3 seconds while the
wrench symbol and distance to oil change are
displayed. The symbol and distance display will
start flashing and the display shows the current
interval. Push the switch to increase the interval
distance. Each step increases the interval distance
by 1,000 km (500 miles). The interval distance
can be set up to 30,000 km (18,000 miles)
after which the display returns to zero.

If no further action is made, the display returns to
oil display status indication and the new interval is
set.

If the interval distance is set to 0, the display will
skip the distance to oil change information and
wrench symbol display mode and will directly
display the oil display status (Oil Good or Oil
Lo). In order to return to the distance to oil
change information and wrench symbol display
mode, push the trip computer change button A
on the instrument panel located near the speedometer
B for approximately 3 seconds after the
ignition switch has been turned to the ON position,
and adjust the distance to oil change schedule
as previously described.