Rear Wheel Hub

REAR WHEEL HUB

Inspection


INSPECTION AFTER REMOVAL

Check the brake drum assembly and spindle for wear, cracks, and damage. Replace if necessary.

INSPECTION AFTER DISASSEMBLY

- Check brake drum for wear, cracks, or any other damage. Replace if necessary.
- Check snap ring for wear or cracks. Replace if necessary.

INSPECTION AFTER INSTALLATION

1.Check wheel bearing rotating torque per the following instructions.
NOTE:
The adequacy of turning torque can be judged from a measurement value by a suitable tool.
a.Check the contact surface of the brake drum and spindle for foreign matter. If there is any foreign matter, clean the contact surface.
b.Check that the wheel hub lock nut is tightened to the specified torque.
c.Turn the brake drum 10 times or more both clockwise and counterclockwise for proper fit.





d.Set a suitable tool to the hub bolt and measure turning torque at turning speeds of 8 to 12 rpm.

Rotating torque, and spring balance mesurement : .

2.Check wheel sensor harness for proper connection. Refer to
Exploded View.
3.Adjust parking brake operation (stroke). Service and Repair.