Removal And Installation

ACCELERATOR CONTROL SYSTEM

Removal and Installation


CAUTION:
- Never disassemble accelerator pedal assembly. Never remove accelerator pedal position sensor from accelerator pedal assembly.
- Avoid impact from dropping etc. during handling.
- Be careful to keep accelerator pedal assembly away from water.

REMOVAL

1.Disconnect the negative battery cable.
2.Disconnect accelerator pedal position sensor harness electrical connector.
3.Remove the accelerator assembly bolts and the accelerator pedal assembly.

INSTALLATION

Installation is in the reverse order of removal.
- When installing the accelerator pedal assembly, align the locating hook and locating pin holes on the brake pedal bracket.

CAUTION:
Never squeeze the locating hook in the break pedal bracket when inserting the locating pin into the hole on the brake pedal bracket side.
- After installation, perform inspection of the accelerator pedal assembly.





- Check that the accelerator pedal moves smoothly within the specified range.
Pedal travel (A): [1][2]Accelerator Pedal.
- Depress and release the accelerator pedal to check that it returns quickly and smoothly to the original released position.
- Perform an electrical inspection of accelerator pedal position sensor. P2122.

CAUTION:
- The accelerator pedal shall operate smoothly without catching, when the pedal operating force is released. The pedal shall return smoothly to the fully raised position. The spring shall be free from damage.
- When harness connector of accelerator pedal position sensor is disconnected, perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING". Testing and Inspection.