Description

ADDITIONAL SERVICE WHEN REPLACING TCM

Description

When replacing the TCM, perform the following work.
- The TCM acquires calibration data (individual characteristic value) of each solenoid that is stored in the
ROM assembly (in the control valve). This enables the TCM to perform accurate control. After the TCM is replaced, check that the TCM has correctly loaded the calibration data.
- TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the replacement of TCM.

CAUTION:
When replacing TCM and transaxle assembly as a set, replace transaxle assembly first and then replace TCM.
If the TCM is replaced in advance, perform "ADDITIONAL SERVICE WHEN REPLACING TRANSAXLE
ASSEMBLY" after "G sensor calibration".