Stall Test

STALL TEST

Work Procedure


INSPECTION

1.Check the engine oil level. Replenish if necessary.
2.Check for leak of the CVT fluid. Inspection.
3.Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80�C (122 to
176�F).
4.Be sure to apply the parking brake and block the tires.
5.Start the engine, depress the brake pedal and put the selector lever to the D position.
6.While depressing the brake pedal, depress the accelerator pedal gradually.
7.Read the stall speed quickly. Then, release your foot from the accelerator pedal quickly.

CAUTION:
Do not depress the accelerator pedal for 5 seconds or more during the test.

Stall speed: Stall Speed.

8.Place the selector lever in the N position.
9.Cool the CVT fluid.

CAUTION:
Run the engine with the idle speed for at least 1 minute.
10.Put the selector lever to the R position and perform Step 6 to Step 9 again.

NARROWING-DOWN MALFUNCTIONING PARTS