Maintenance Indicator Reset

Resetting Maintenance Indicators

Engine Oil Replacement Indicator





This indicator appears when the set time comes for changing the engine oil. You can set or reset the distance for changing the engine oil using the trip computer.





Switches for the trip computer are located on the left side of the combination meter panel. To operate the trip computer, push the switches as shown above.

(A) - ENTER switch
(B) - NEXT switch

When the ignition switch is pushed to the ON position, modes of the trip computer can be selected by pushing the ENTER switch (A).
Each time switch (A) is pushed the display will cycle through the choices.

Note: Setting cannot be made while driving.

Switch (A) and switch (B) are used in the setting mode to select and decide a menu.





Skip:
Push switch (A) to move to the warning check mode.
Push switch (B) to select other menus.

Select "MAINTENANCE" and select the submenu for "ENGINE OIL" to set or reset the distance for replacing the engine oil.
To return to the top page of the setting mode, select "BACK".