B2632

B2632, B2633 AIR MIX DOOR MOTOR (DRIVER SIDE)

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT
1.Turn ignition switch ON.
2.Using CONSULT, perform "SELF-DIAGNOSIS RESULTS" of HVAC.
3.Check if any DTC No. is displayed in the self-diagnosis results.
Is DTC detected?
YES- Refer to "Diagnosis Procedure" .
NO- Inspection End.


Diagnosis Procedure

Regarding Wiring Diagram information, refer to "Wiring Diagram" Automatic Air Conditioning.

1. CHECK AIR MIX DOOR MOTOR LH COMMUNICATION SIGNAL

1.Turn ignition switch ON.
2.Check output waveform between air mix door motor LH harness connector and ground with the oscilloscope.





Is the inspection result normal?
YES- GO TO 2.
NO- GO TO 3.

2. CHECK INSTALLATION OF AIR MIX DOOR MOTOR LH

Check air mix door motor LH is properly installed. Refer to "Exploded View" Exploded View.
Is the inspection result normal?
YES- Replace air mix door motor LH. Refer to "AIR MIX DOOR MOTOR : Removal and Installation Air Mix Door Motor RH" Removal And Installation - Air Mix Door Motor RH.
NO- Repair or replace malfunctioning part.

3. CHECK AIR MIX DOOR MOTOR LH COMMUNICATION SIGNAL CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect air mix door motor LH and A/C auto amp. connector.
3.Check continuity between air mix door motor LH harness connector and A/C auto amp. harness connector.





Is the inspection result normal?
YES- Replace A/C auto amp. Refer to "Removal and Installation" Removal And Installation.
NO- Repair harness or connector.