B26F6

B26F6 BCM

DTC Logic


DTC DETECTION LOGIC

NOTE:
- If DTC B26F6 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
"DTC Logic" Power Distribution System.
- If DTC B26F6 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to
"DTC Logic" Power Distribution System.






DTC CONFIRMATION PROCEDURE


1. PERFORM SELF DIAGNOSTIC RESULT

1.Turn ignition switch ON under the following conditions, and wait for 2 seconds or more.
-CVT selector lever is in the P (park) or N (neutral) position.
-Do not depress brake pedal.
2.Perform self diagnostic result.
Is DTC B26F6 detected?
YES- Go to "Diagnosis Procedure" .
NO- Inspection End.


Diagnosis Procedure

Regarding Wiring Diagram information, refer to "Wiring Diagram" Power Distribution System.

1. CHECK SELF DIAGNOSTIC RESULT FOR IPDM E/R

Perform self diagnostic result for IPDM E/R.
Are any DTCs detected?
YES- Refer to "DTC Index" Testing and Inspection.
NO- GO TO 2

2. CHECK IGNITION RELAY-1 POWER SUPPLY (IPDM E/R)

Check voltage between IPDM E/R connector E63 terminal 43 and ground.





Is the inspection result normal?
YES- Replace IPDM E/R. Refer to "Removal and Installation" Service and Repair.
NO- GO TO 3.

3. CHECK IGNITION RELAY-1 POWER SUPPLY (BCM)

Check voltage between BCM connector M18 terminal 70 and ground.










Is the inspection result normal?
YES- Refer to "Intermittent Incident" Intermittent Incident.
NO- Replace BCM. Refer to "Removal and Installation" Service and Repair.