CVT RE0F10E

P0746 PRESSURE CONTROL SOLENOID A

DTC Logic


DTC DETECTION LOGIC






NOTE:
DC stands for "DRIVING CYCLE" and indicates a series of driving cycle of "Ignition switch OFF --> ON --> driving --> OFF".

DTC CONFIRMATION PROCEDURE


CAUTION:
Be careful of the driving speed.

1. PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
- GO TO 2.

2. CHECK DTC DETECTION

1.Start the engine.
2.Drive the vehicle.
3.Maintain the following conditions for 10 seconds or more.

Selector lever : "D" position
Accelerator pedal position : 0.5/8 or more
Vehicle speed : 40 km/h (25 MPH) or more

4.Stop the vehicle.
5.Check the first trip DTC.
Is "P0746"detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
Is the inspection result normal?
YES- Replace transaxle assembly. Refer to "Removal and Installation" Removal And Installation.
NO- Repair or replace the malfunction items.