CVT RE0F10D

P2813 SELECT SOLENOID

DTC Logic


DTC DETECTION LOGIC






NOTE:
DC stands for "DRIVING CYCLE" and indicates a series of driving cycle of "Ignition switch OFF --> ON --> driving --> OFF".

DTC CONFIRMATION PROCEDURE


CAUTION:
Be careful of the driving speed.

1. PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
- GO TO 2.

2. CHECK DTC DETECTION 1

1.Start the engine.
2.Maintain the following conditions. (Keep 30seconds or more after the selector lever shifted.)

Selector lever : N --> D, N --> R, P --> R

3.Check the first trip DTC.
Is "P2813"detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
Is the inspection result normal?
YES - Replace transaxle assembly. Refer to "Removal and Installation" Removal And Installation.
NO- Repair or replace malfunctioning parts.