CVT RE0F10E

P2815 SELECT SOLENOID

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
- GO TO 2.

2. CHECK DTC DETECTION

1.Start the engine.
2.Maintain the following conditions. (Keep 5 seconds or more after the selector lever shifted.)

Selector lever N --> D, N --> R, P --> R

3.Check the first trip DTC.
Is "P2815" detected?
YES- Go to "Diagnosis Procedure" CVT RE0F10D.
NO- INSPECTION END


Diagnosis Procedure


1. CHECK CIRCUIT BETWEEN TCM AND CVT UNIT

1.Turn ignition switch OFF.
2.Disconnect TCM connector and CVT unit connector.
3.Check continuity between TCM harness connector terminal and ground.





Is the inspection result normal?
YES - GO TO 2.
NO- Repair or replace damaged parts.

2. CHECK CIRCUIT BETWEEN CVT UNIT AND GROUND

Check continuity between CVT unit harness connector terminal and ground.





Is the inspection result normal?
YES - Check intermittent incident. Refer to "Intermittent Incident" Intermittent Incident.
NO- GO TO 3.

3. CHECK CIRCUIT BETWEEN CVT UNIT AND CONTROL VALVE

1.Disconnect control valve connector. Refer to "Removal and Installation" Removal And Installation.
2.Check continuity between CVT unit harness connector terminal and control valve harness connector terminal.





Is the inspection result normal?
YES - GO TO 4.
NO- Replace terminal cord assembly. Refer to "Removal and Installation" Removal And Installation.

4. CHECK CIRCUIT BETWEEN CONTROL VALVE AND GROUND

Check continuity between CVT unit harness connector terminal and ground.





Is the inspection result normal?
YES - Check intermittent incident. Refer to "Intermittent Incident" Intermittent Incident.
NO- There is malfunction of select solenoid solenoid valve. Replace transaxle assembly. Refer to TM408, "Removal and Installation".