CVT RE0F10D

U0300 CAN COMMUNICATION DATA

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
- GO TO 2.

2. CHECK DTC DETECTION

1.Start the engine and wait for 5 seconds or more.
2.Check the DTC.
Is "U0300" detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CONTROL UNIT CHECK

Check the number of control units replaced before "U0300" is detected.
Is one control unit replaced?
YES- The specification of the control unit replaced may be incorrect. Check the part number and the specification.
NO- GO TO 2.

2. CONTROL UNIT CHECK

With CONSULT
1.Remove one of the control unit replaced.
2.Assemble the old control unit before replacement.
3.Turn ignition switch ON, and wait for 2 seconds or more.
4.Select "Self Diagnostic Results" in "TRANSMISSION".
Is "U0300"detected?
YES- Turn OFF the ignition switch and check other control units in the same manner.
NO- The specification of the control unit removed may be incorrect. Check the part number and the specification.