Seatback Latch Assembly

REAR SEAT

Removal and Installation - Seatback Latch Assembly


REMOVAL

1.Remove the rear seat bolster (LH/RH). Refer to "Removal and Installation Rear Seat Bolster" Rear Seat Bolster.
2.Place the rear seatback assemblies (LH/RH) in the folded down position.
3.Remove the rear seatback finisher. Refer to "Exploded View" Exploded View.





4.From trunk area release pawls (A) to open cable guide (1).
5.Unclip latch cable (2) at location (B).
White arrow indicates : Front

NOTE:
LH side shown; RH side similar.
6.Remove two seatback latch assembly bolts and the seatback latch assembly.

INSTALLATION

Installation is in the reverse order of removal.
- Tighten two seatback latch assembly bolts to specification. Refer to "Exploded View" Exploded View.