Work Procedure

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (A/C AUTO AMP.)

Work Procedure


1. SAVING VEHICLE SPECIFICATION

CONSULT
Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.
NOTE:
If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing A/C auto amp.
- GO TO 2.

2. REPLACE A/C AUTO AMP.

Replace A/C auto amp. Refer to "Removal and Installation" Removal And Installation.
- GO TO 3.

3. WRITING VEHICLE SPECIFICATION

CONSULT
1.Enter "Re/Programming, Configuration".
2.If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to "Work Procedure" Work Procedure.
3.If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to "Work Procedure" Work Procedure.
- GO TO 4.

4. OPERATION CHECK

Check that the operation of the A/C auto amp. is normal.
- Work End.