Combination Switch Output Circuit

COMBINATION SWITCH OUTPUT CIRCUIT

Diagnosis Procedure

Regarding Wiring Diagram information, refer to "Wiring Diagram" [1][2]Body Control Module.

1. CHECK OUTPUT 1 - 5 SYSTEM CIRCUIT FOR OPEN

1.Turn ignition switch OFF.
2.Disconnect BCM connector M17 and combination switch connector.
3.Check continuity between BCM connector M17 and combination switch connector.





Is the inspection result normal?
YES- GO TO 2.
NO- Repair or replace harness or connectors.

2. CHECK OUTPUT 1 - 5 SYSTEM CIRCUIT FOR SHORT

Check continuity between BCM connector M17 and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace harness or connectors.

3. CHECK BCM INPUT VOLTAGE

1.Connect BCM connector M17 and combination switch connector.
2.Turn ignition switch ON.
3.Check voltage between BCM connector M17 and ground.





Is the inspection result normal?
YES- Replace BCM. Refer to "Removal and Installation" Service and Repair.
NO- Replace the combination switch.