Disassembly And Assembly - LED

REAR COMBINATION LAMP

Disassembly and Assembly - LED


REAR COMBINATION LAMP - LED


WARNING:
Do not touch bulb while it is lit or right after being turned off. Burning may result.

CAUTION:
- Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Do not leave the bulb out of the lamp reflector for a long time because dust, moisture, smoke, etc.
may affect the performance of the lamp.
Disassembly
1.Remove rear combination lamp. Refer to "Removal and Installation" Removal And Installation.
2.Rotate rear turn signal lamp bulb socket counterclockwise to remove from rear combination lamp.
3.Remove the rear turn signal lamp bulb from bulb socket.
4.Rotate back-up lamp bulb socket counterclockwise to remove from rear combination lamp.
5.Remove the back-up lamp bulb from bulb socket.
6.Disconnect the harness connector from the LED lamp.
7.Rotate side marker lamp bulb socket counterclockwise to remove from rear combination lamp.
8.Remove the side marker lamp bulb from bulb socket.
Assembly
Assembly is in the reverse order of disassembly.

CAUTION:
After installing, be sure to install the bulb sockets securely to ensure watertightness.