Rear Combination Lamp

REAR COMBINATION LAMP

Bulb Replacement


WARNING:
Do not touch bulb while it is lit or right after being turned off. Burning may result.

CAUTION:
- Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Do not leave the bulb out of the lamp reflector for a long time because dust, moisture, smoke, etc.
may affect the performance of the lamp.

REAR TURN SIGNAL LAMP BULB

Removal
1.Remove the rear combination lamp. Refer to "Removal and Installation" Removal And Installation.
2.Rotate the rear turn signal lamp bulb socket counterclockwise and remove.
3.Remove the rear turn signal lamp bulb from the bulb socket.
Installation
Installation is in the reverse order of removal.

CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.

STOP/TAIL LAMP BULB (IF EQUIPPED)

Removal
1.Remove the rear combination lamp. Refer to "Removal and Installation" Removal And Installation.
2.Rotate the stop/tail lamp bulb socket counterclockwise and remove.
3.Remove the stop/tail lamp bulb from the bulb socket.
Installation
Installation is in the reverse order of removal.

CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.

STOP/TAIL LAMP LED (IF EQUIPPED)

The stop/tail lamp LED is integrated into the rear combination lamp and is serviced as an assembly. Refer to
"Removal and Installation" Removal And Installation.

BACK-UP LAMP BULB

Removal
1.Remove the rear combination lamp. Refer to "Removal and Installation" Removal And Installation.
2.Rotate the back-up lamp bulb socket counterclockwise and remove.
3.Remove the back-up lamp bulb from the bulb socket.
Installation
Installation is in the reverse order of removal.

CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.

SIDE MARKER LAMP BULB

Removal
1.Remove the rear combination lamp. Refer to "Removal and Installation" Removal And Installation.
2.Rotate the side marker lamp bulb socket counterclockwise and remove.
3.Remove the side marker lamp bulb from the bulb socket.
Installation
Installation is in the reverse order of removal.

CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.