Work Procedure

ADDITIONAL SERVICE WHEN REPLACING TRANSAXLE ASSEMBLY

Work Procedure


1. CHECK THE SERIAL NUMBER (PART 1)

Write down the serial number of new transaxle assembly.





- GO TO 2.

2. CHECK THE SERIAL NUMBER (PART 2)

1.Turn ignition switch ON.
2.Insert the attached CD into CONSULT.
3.Select "Work Support" in "TRANSMISSION".
4.Select "WRITE IP CHARA - REPLACEMENT AT/CVT".
5.Check that the serial number displayed on CONSULT screen and those written in the memo agree.

CAUTION:
Never perform writing procedure.
6.Go back to MENU of "Work Support".
- GO TO 3.

3. INITIALIZE TCM

1.Set parking brake.
2.Select "ERASE MEMORY DATA".
3.Touch "Start" according to the instructions on the CONSULT screen.
Is "COMPLETED" displayed?
YES- GO TO 4.
NO- Turn ignition switch OFF and wait for a minimum of 10 seconds then perform the work again.

4. WRITE THE DATA

NOTE:
Write data of new solenoid in TCM according to the following instructions:
1.Shift the selector lever to the P position.
2.Turn ignition switch OFF and wait for 10 seconds.
3.Turn ignition switch ON.
4.Select "Work Support" in "TRANSMISSION".
5.Select "WRITE IP CHARA - REPLACEMENT AT/CVT".
6.Write data in TCM according to the instructions on the CONSULT screen.
NOTE:
When writing is complete, the shift position indicator of the combination meter displays P.
- GO TO 5.

5. ERASE CVT FLUID DEGRADATION LEVEL DATA

1.Select "WORK SUPPORT" in "TRANSMISSION".
2.Select "CONFORM CVTF DETERIORTN".
3.Touch "Clear".
- WORK END