Without Navigation

INSPECTION AND ADJUSTMENT

ADDITIONAL SERVICE WHEN REPLACING AV CONTROL UNIT : Work Procedure


1. SAVING VEHICLE SPECIFICATION

-CONSULT
Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.
NOTE:
If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing AV control unit.
- GO TO 2.

2. REPLACE AV CONTROL UNIT

Replace AV control unit. Refer to "Removal and Installation" Without Navigation.
- GO TO 3.

3. WRITING VEHICLE SPECIFICATION

CONSULT
1.Enter "Re/Programming, Configuration".
2.If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to "CONFIGURATION (AV CONTROL UNIT) : Work Procedure" Without Navigation.
3.If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to "CONFIGURATION (AV CONTROL UNIT) : Work Procedure" Without Navigation.
- GO TO 4.

4. OPERATION CHECK

Check that the operation of the AV control unit and camera images (fixed guide lines) are normal.
- Work End.