LH & RH Front Anti-Pinch

FRONT POWER WINDOW SWITCH

Removal and Installation


REMOVAL

1.Remove the front door pull handle outer finisher using a suitable tool.
2.Release the pawls using a suitable tool and lift the power window and door lock/unlock switch RH and finisher as an assembly by starting at the rear, then pull upward and remove.
3.Disconnect the harness connector from the power window and door lock/unlock switch RH.





4.Release the four pawls (two on each side) using a suitable tool, then separate the main power window and door lock/unlock switch RH (1) from the main power window and door lock switch RH finisher (2).
Broken circle indicates : Pawl

CAUTION:
Do not bend back the pawls on the switch finisher too far or breakage may occur.

INSTALLATION

Installation is in the reverse order of removal.