LH Front Only Anti-Pinch
FRONT POWER WINDOW SWITCH
Removal and Installation
REMOVAL
1.Remove the front door pull handle outer finisher using a suitable tool.
2.Release the pawls using a suitable tool and lift the power window switch RH and door lock/unlock RH finisher as an assembly by starting at the rear, then pull upward and remove.
3.Disconnect the harness connector from the power window and door lock/unlock switch RH.
4.Release the four pawls (two on each side) using a suitable tool, then separate the power window and door lock/unlock switch
RH (1) from the power window and door lock/unlock switch finisher RH (2).
Broken circle indicates : Front
CAUTION:
Do not bend back the pawls on the switch finisher too far or breakage may occur.
INSTALLATION
Installation is in the reverse order of removal.