ITS CONTROL UNIT

ACTION TEST

Inspection Procedure


WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:
- Fully understand the following items well before the road test;
- Precautions: Refer to "Precaution for LDW System Service" Precaution for LDW System Service.
- System description for LDW: Refer to "System Description" LDW.
- System description for BSW: Refer to "System Description" BSW.
- System description for MOD: Refer to "System Description" MOD.
- Handling precaution: Refer to "Precautions for Moving Objects Detection" Precautions For Moving Objects Detection.

1. CHECK LDW SYSTEM SETTING

1.Start the engine.
2.Check that the LDW system setting can be enabled/disabled on the vehicle information display.
3.Turn OFF the ignition switch and wait for 30 seconds or more.
4.Check that the previous setting is saved when the engine starts again.
- GO TO 2.

2. ACTION TEST FOR LDW

1.Enable the setting of the LDW system on the vehicle information display.
2.Turn warning systems switch ON (warning systems ON indicator is ON).
3.Check the LDW operation according to the following table.










NOTE:
After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 60 km/h (40 MPH). Refer to "System Description" LDW.
- Inspection End.