Work Procedure

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT

ECM : Work Procedure


1. PERFORM ECM RECOMMUNICATING FUNCTION

1.Install ECM.
2.Contact backside of registered Intelligent key* to push-button ignition switch, then turn ignition switch to
ON.
*: To perform this step, use the key that is used before performing ECM replacement.
3.Maintain ignition switch in the ON position for at least 5 seconds.
4.Turn ignition switch to OFF.
5.Check that the engine starts.
- GO TO 2.

2. PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM

Perform "Work Procedure" Work Procedure.
- Inspection End.