Precaution For Liquid Gasket

PRECAUTIONS

Precaution for Liquid Gasket


REMOVAL OF LIQUID GASKET






- After removing the bolts and nuts, separate the mating surface and remove the liquid gasket using Tool (A).
Tool Number: KV10111100 (J-37228)

CAUTION:
Be careful not to damage the mating surfaces.
- In areas where the cutter is difficult to use, use a plastic hammer to lightly tap (1) the cutter where the liquid gasket is applied. Use a plastic hammer to slide (2) the cutter by tapping on the side.

CAUTION:
Do not damage the mating surfaces.

LIQUID GASKET APPLICATION PROCEDURE






1.Using a scraper, remove the old liquid gasket adhering to the gasket application surface and the mating surface.
- Remove the liquid gasket completely from the groove of the gasket application surface, mounting bolts, and bolt holes.
2.Thoroughly clean the gasket application surface and the mating surface and remove adhering moisture, grease and foreign materials.
3.Attach the liquid gasket tube to the tube presser.
Use Genuine Silicone RTV Sealant or equivalent. Refer to
"Recommended Chemical Products and Sealants" Recommended Chemical Products And Sealants.





4.Apply the liquid gasket using suitable tool without breaks to the specified location.
- If there is a groove for the liquid gasket application, apply the liquid gasket to the groove.





- As for the bolt holes, normally apply the liquid gasket inside the holes. If specified, it should be applied outside the holes.
Make sure to read the text of this manual.
- Within five minutes of the liquid gasket application, install the mating component.
- If the liquid gasket protrudes, wipe it off immediately.
- Do not retighten after the installation.
- After 30 minutes or more have passed from the installation, fill the engine with the specified oil and coolant.

CAUTION:
If there are more specific instructions in the procedures contained in this manual concerning liquid gasket application, observe them.