Bulb Replacement

TURN SIGNAL AND HAZARD WARNING LAMPS

Bulb Replacement


WARNING:
- Do not touch bulb by hand while it is lit or right after being turned off. Burning may result.

CAUTION:
- Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Do not leave the bulb out of the lamp reflector for a long time because dust, moisture, smoke, etc.
may affect the performance of the lamp.

REMOVAL

1.Remove the front fender protector side cover.
2.Position the front fender protector aside. Refer to "FENDER PROTECTOR : Removal and Installation" Removal And Installation.
3.Disconnect the harness connector from the turn signal and hazard warning lamp.
4.Rotate the turn signal and hazard warning lamp bulb socket counterclockwise and remove it.
5.Remove turn signal and hazard warning lamp bulb from the bulb socket.

Installation

Installation is in the reverse order of removal.

CAUTION:
After installing, be sure to install the bulb socket securely to ensure watertightness.