With LH And RH Anti-Pinch

DOOR LOCK AND UNLOCK SWITCH

PASSENGER SIDE : Diagnosis Procedure (With LH and RH Anti-Pinch)

Regarding Wiring Diagram information, refer to "Wiring Diagram" [1][2]Electrical Diagrams.

1. CHECK POWER WINDOW SWITCH OUTPUT SIGNAL

1.Read voltage signal between BCM connector and ground with oscilloscope when power window and door lock/unlock switch RH is changed to "LOCK" or "UNLOCK".
2.Check that signals which are shown in the figure below can be detected during 10 second just after power window and door lock/unlock switch RH is changed "LOCK" or "UNLOCK".





Is the inspection result normal?
YES- GO TO 4
NO- GO TO 2

2. CHECK POWER WINDOW SWITCH GROUND

1.Turn ignition switch OFF.
2.Disconnect power window and door lock/unlock switch RH connector.
3.Check continuity between power window and door lock/unlock switch RH connector and ground.





Is the inspection result normal?
YES- GO TO 3
NO- Repair or replace harness.

3. CHECK POWER WINDOW SERIAL LINK CIRCUIT

1.Disconnect BCM connector.
2.Check continuity between BCM connector and power window and door lock/unlock switch RH connector.





3.Check continuity between BCM connector and ground.





Is the inspection result normal?
YES- GO TO 4
NO- Repair or replace harness.

4. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
YES- Inspection End.