Removal And Installation

WASHER LEVEL SWITCH

Removal and Installation


REMOVAL

1.Drain the washer fluid.
2.Remove the front under cover. Refer to "Removal and Installation" Removal And Installation.
3.Remove the fender protector (RH). Refer to "FENDER PROTECTOR : Removal and Installation" Removal And Installation.
4.Disconnect the harness connector from the washer level switch.
5.Remove the washer level switch.
6.Remove the washer tank seal (if necessary).

INSTALLATION

Installation is in the reverse order of removal.
NOTE:
- After installation, add water to the top of the washer tank inlet to check that no leaks exist.
- Fill washer tank with specified amount of fluid.