Removal And Installation

CONTROL CABLE

Removal and Installation


CAUTION:
Always apply the parking brake before performing removal and installation.

INSTALLATION

1.Apply the parking brake.

CAUTION:
Make sure the vehicle cannot move with the parking brake applied.
2.Remove the front air duct and air cleaner case assembly. Refer to "Removal and Installation" .





3.Remove the control cable nut (black arrow), using suitable tool.
4.Remove control cable (2) from manual lever (A).
5.Remove the lock plate (3) from control cable (2).
6.Remove control cable (2) from bracket (1).
7.Remove center console. Refer to "Removal and Installation" Removal And Installation.
8.Disconnect the ITS control unit harness connectors and remove the ITS control unit (if equipped). Refer to
"Removal and Installation" ITS Control Unit.





9.Remove control cable (1) from the CVT shift selector assembly (2).
(A): Ribbed surface
10.Pull back dash trim and remove two retainer grommet bolts.
11.Thread the control cable through the sheet metal and remove the control cable from the vehicle.

INSTALLATION

Installation is in the reverse order of removal.





- When installing control cable (1) to the CVT shift selector assembly (2), check that control cable is fully pressed in until it stops with the ribbed surface (A) facing upward.
NOTE:
Apply multi-purpose grease to control cable eye before installation.
- Adjust control cable as necessary. Refer to "Inspection and Adjustment" CVT RE0F10E.