B2110

B2110 SHIFT POSITION/CLUTCH INTERLOCK SWITCH

DTC Logic


DTC DETECTION LOGIC

NOTE:
If DTC B2110 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS59, "DTC Logic".






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Shift selector lever to the P position.
2.Turn ignition switch ON and wait 1 second or more.
3.Shift selector lever to the N position and wait 1 second or more.
4.Shift selector lever to the position other than P and N, and wait 1 second or more.
5.Check DTC in Self Diagnostic Result mode of IPDM E/R using CONSULT.
Is DTC detected?
YES- Go to "Diagnosis Procedure" .
NO- Inspection End.


Diagnosis Procedure

Regarding Wiring Diagram information, refer to "Wiring Diagram" Intelligent Key System/Engine Start Function.

1. CHECK DTC OF BCM

Check DTC in Self Diagnostic Result mode of BCM using CONSULT.
Is DTC detected?
YES- Perform the trouble diagnosis related to the detected DTC. Refer to "DTC Index" Testing and Inspection.
NO- GO TO 2.

2. CHECK IPDM E/R SIGNAL CIRCUIT OPEN AND SHORT

1.Turn ignition switch OFF.
2.Disconnect IPDM E/R connector.
3.Disconnect transmission range switch connector.
4.Check continuity between IPDM E/R harness connector and transmission range switch harness connector.





5.Check continuity between IPDM E/R harness connector and ground.





Is the inspection result normal?
YES- Replace IPDM E/R. Refer to "Removal and Installation" IPDM E/R (With I-Key).
NO- Repair or replace harness.