With Intelligent Key System

B2195 ANTI-SCANNING

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn ignition switch ON.
2.Check DTC in Self Diagnostic Result mode of BCM using CONSULT.
Is DTC detected?
YES- Refer to "Diagnosis Procedure" .
NO- Inspection End.


Diagnosis Procedure


1. CHECK SELF DIAGNOSTIC RESULT 1

1.Select Self Diagnostic Result mode of BCM using CONSULT.
2.Erase DTC.
3.Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to "DTC Logic" .
Is DTC detected?
YES- GO TO 2.
NO- Inspection End.

2. CHECK EQUIPMENT OF THE VEHICLE

Check that unspecified accessory part related to engine start is not installed.
Is unspecified accessory part related to engine start installed?
YES- GO TO 3.
NO- GO TO 4.

3. CHECK SELF DIAGNOSTIC RESULT 2

1.Obtain the customers approval to remove unspecified accessory part related to engine start, and then remove it.
2.Select Self Diagnostic Result of BCM using CONSULT.
3.Erase DTC.
4.Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to "DTC Logic" .
Is DTC detected?
YES- GO TO 4.
NO- Inspection End.

4. REPLACE BCM

1.Replace BCM. Refer to "Removal and Installation" Service and Repair.
2.Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.
- Inspection End.