U0415

U0415 VEHICLE SPEED

DTC Logic


DTC DETECTION LOGIC

NOTE:
- If DTC U0415 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
"DTC Logic" With Intelligent Key System.
- If DTC U0415 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to
"DTC Logic" With Intelligent Key System.






DTC CONFIRMATION PROCEDURE


1. DTC CONFIRMATION

1.Erase the DTC.
2.Turn ignition switch OFF.
3.Perform Self Diagnostic Result of BCM with CONSULT, after the ignition switch has been turned ON for 2
seconds or more.
Is any DTC detected?
YES- Refer to "DTC Index" Testing and Inspection.
NO- Inspection End.


Diagnosis Procedure


1. ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF DIAGNOSTIC RESULT

Perform Self Diagnostic Result of ABS with CONSULT. Refer to "CONSULT Function (ABS)" Scan Tool Testing and Procedures.
Is any DTC detected?
YES- Perform the trouble diagnosis related to the detected DTC. Refer to "DTC Index" Testing and Inspection.
NO- GO TO 2.

2. CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND

CIRCUIT
Check ABS actuator and electric unit (control unit) power and ground. Refer to "Diagnosis Procedure" C1109.
Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace harness or connectors.

3. COMBINATION METER SELF DIAGNOSTIC RESULT

Perform Self Diagnostic Result of METER M&A with CONSULT. Refer to "CONSULT Function" Type A.
Is any DTC detected?
YES- Perform the trouble diagnosis related to the detected DTC. Refer to "DTC Index" Testing and Inspection.
NO- Refer to "Intermittent Incident" Intermittent Incident.