Without Intelligent Key System

NATS ANTENNA AMP.

Removal and Installation

NOTE:
- If NATS antenna amp. is not installed correctly, NVIS (NATS) system will not operate properly and "SELF-DIAG RESULTS" on CONSULT screen will show "LOCK MODE" or "CHAIN OF IMMU-KEY".
- Initialization is not necessary when only the NATS antenna amp. is replaced with a new one.

REMOVAL

1.Disconnect the battery negative terminal. Refer to "Removal and Installation" Removal and Replacement.
2.Remove the instrument lower panel LH. Refer to "Removal and Installation" Instrument Lower Panel LH.





3.Remove the NATS antenna amp bolt (A).
4.Disconnect the harness connector (1) from the NATS antenna amp. (2) and remove.

INSTALLATION

Installation is in the reverse order of removal.