Vehicle Security Indicator

VEHICLE SECURITY INDICATOR

Description

- Vehicle security indicator is built in combination meter.
- NATS (Nissan Anti-Theft System) condition is indicated by blink or illumination of vehicle security indicator.


Component Function Check


1. CHECK FUNCTION

1.Perform Active Test of THEFT IND in the IMMU mode with CONSULT.
2.Check vehicle security indicator operation.





Is the inspection result normal?
YES- Inspection End.
NO- Refer to "Diagnosis Procedure" .


Diagnosis Procedure

Regarding Wiring Diagram information, refer to "Wiring Diagram" NVIS.

1. SECURITY INDICATOR LAMP ACTIVE TEST

With CONSULT
Check "THEFT IND" in "ACTIVE TEST" of IMMU mode with CONSULT.
Without CONSULT
1.Disconnect BCM.
2.Check voltage between BCM harness connector M18 terminal 23 and ground.





Is the inspection result normal?
YES- Security indicator lamp is OK.
NO- GO TO 2

2. SECURITY INDICATOR LAMP CHECK

Check security indicator lamp condition.
Is the inspection result normal?
YES- GO TO 3
NO- Replace combination meter. Refer to "Removal and Installation" Type A (type A) or "Removal and Installation" Type B (type B).

3. CHECK HARNESS CONTINUITY

1.Turn ignition switch OFF.
2.Disconnect BCM and security indicator lamp connector.
3.Check continuity between BCM connector M18 terminal 23 and combination meter type A connector M82
terminal 18 or type B connector M24 terminal 31.
Type A: 23 - 18: Continuity should exist.
Type B: 23 - 31: Continuity should exist.
4.Check continuity between BCM connector M18 terminal 23 and ground.
23 - Ground: Continuity should not exist.
Is the inspection result normal?
YES-Check the following:
- 10A fuse [No. 8, located in fuse block (J/B)]
- Harness for open or short between security indicator lamp and fuse
NO- Repair or replace harness.