With Intelligent Key System

REAR DOOR

DOOR ASSEMBLY : Adjustment











Check the clearance and surface height between rear door and each part by visually and touching.
If the clearance and the surface height are out of specification, adjust them according to the adjustment procedure.
Unit: mm (in)






ADJUSTMENT PROCEDURE

1.Remove center pillar lower finisher. Refer to "CENTER PILLAR LOWER FINISHER : Removal and Installation" Center Pillar Lower Finisher.
2.Loosen door hinge nuts on door side.
3.Adjust the surface height of rear door according to the specifications provided.
4.Temporarily tighten door hinge nuts on door side.
5.Loosen door hinge nuts and bolts on body side.
6.Raise rear door at rear end to adjust clearance of rear door according to the specifications provided.
7.After adjustment tighten bolts and nuts to the specified torque.

CAUTION:
- Apply touch-up paint (body color) onto the head of hinge bolts and nuts.
- Check door hinge rotating point for poor lubrication. If necessary, apply a suitable multi-purpose grease.
8.Install center pillar lower finisher. Refer to "CENTER PILLAR LOWER FINISHER : Removal and Installation" Center Pillar Lower Finisher.

DOOR STRIKER ADJUSTMENT

Adjust door striker so that it becomes parallel with door lock insertion direction.