Removal And Installation

REAR COMBINATION LAMP

Removal and Installation


REMOVAL

1.Remove trunk rear finisher. Refer to. "TRUNK REAR PLATE : Removal and Installation" Trunk Rear Plate.
2.Remove rear combination lamp nuts.





3.Disengage the locating pin (A) of the rear combination lamp using a suitable tool (B) at the gap between the rear combination lamp and rear fender.

CAUTION:
Apply protective tape (C) on body to protect the painted surface from damage.
4.Disconnect the harness connectors from the rear combination lamp and remove.

INSTALLATION

Installation is in the reverse order of removal.