Removal And Installation

ACCELERATOR CONTROL SYSTEM

Removal and Installation


CAUTION:
- Do not disassemble accelerator pedal assembly. Do not remove accelerator pedal position sensor from accelerator pedal assembly.
- Avoid impact from dropping etc. during handling.
- Be careful to keep accelerator pedal assembly away from water.

REMOVAL

1.Disconnect the battery negative terminal. Refer to "Removal and Installation" Removal and Replacement.
2.Disconnect the harness connector from the accelerator pedal position sensor.
3.Remove the accelerator pedal assembly bolts and the accelerator pedal assembly.

INSTALLATION

Installation is in the reverse order of removal.
- When installing the accelerator pedal assembly, align the locating hook and locating pin holes on the brake pedal bracket.

CAUTION:
Do not squeeze the locating hook in the break pedal bracket when inserting the locating pin into the hole on the brake pedal bracket side.
- After installation, perform inspection of the accelerator pedal assembly.





- Check that the accelerator pedal moves smoothly within the specified range.
Accelerator : Refer to {LINK_TO:0000000008666832}, "Accelerator

pedal travel (A)Control".
- Depress and release the accelerator pedal to check that it returns quickly and smoothly to the original released position.
- Perform an electrical inspection of accelerator pedal position sensor. Refer to "Component Inspection" P2122.

CAUTION:
- Whenever the harness connector of accelerator pedal position sensor is disconnected, perform "ACCELERATOR
PEDAL RELEASED POSITION LEARNING". Refer to "Work Procedure" Testing and Inspection.
- The accelerator pedal should return smoothly without catching to the fully raised position.