Electrical Load Signal

ELECTRICAL LOAD SIGNAL

Description

The electrical load signal (Headlamp switch signal, rear window defogger switch signal, etc.) is transferred to
ECM through the CAN communication line.


Component Function Check


1. CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION

1.Turn ignition switch ON.
2.Select "DATA MONITOR" mode with CONSULT.
3.Select "LOAD SIGNAL" and check indication under the following conditions.





Is the inspection result normal?
YES- GO TO 2.
NO- Go to "Diagnosis Procedure" .

2. CHECK LIGHTING SWITCH FUNCTION

Check "LOAD SIGNAL" indication under the following conditions.





Is the inspection result normal?
YES- GO TO 3.
NO- Go to "Diagnosis Procedure" .

3. CHECK HEATER FAN CONTROL SWITCH FUNCTION

Select "HEATER FAN SW" and check indication under the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- Go to "Diagnosis Procedure" .


Diagnosis Procedure


1. INSPECTION START

Confirm the malfunctioning circuit (rear window defogger, headlamp or heater fan). Refer to "Component Function Check" .
Which circuit is related to the incident?
Rear window defogger-GO TO 2
Headlamp-GO TO 3.
Heater fan-GO TO 4.

2. CHECK REAR WINDOW DEFOGGER SYSTEM

Perform trouble diagnosis of rear window defogger system. Refer to "Work Flow" Initial Inspection and Diagnostic Overview.
- INSPECTION END

3. CHECK HEADLAMP SYSTEM

Perform trouble diagnosis of headlamp system. Refer to "Work Flow" Exterior Lighting.
- INSPECTION END

4. CHECK AIR CONDITIONING SYSTEM

Perform trouble diagnosis of air conditioning system. Refer to "Work flow" Heating And Air Conditioning.
- INSPECTION END