Removal And Installation
SPARK PLUG
Removal and Installation
REMOVAL
1.Remove ignition coil. Refer to "Removal and Installation" Removal And Installation.
CAUTION:
Do not drop or shock ignition coil.
2.Remove spark plug using a suitable tool.
Diameter (a): 14 mm (0.55 in)
CAUTION:
Do not drop or shock spark plug.
INSPECTION AFTER REMOVAL
- If the spark plug tip is covered with carbon, a spark plug cleaner may be used.
Cleaner air pressure: Less than 588 kPa (6 kg/cm2, 85 psi)
Cleaning time: Less than 20 seconds
CAUTION:
Do not use a wire brush for cleaning.
- Checking and adjusting spark plug gap is not required between change intervals. Do not adjust the gap; replace the spark plug as necessary if out of specification.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Do not drop or shock the spark plug.