Side Air Bag (Satellite) Sensor

SIDE AIR BAG (SATELLITE) SENSOR

Removal and Installation






















WARNING:
- Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
- Do not use air tools or electric tools for servicing.

CAUTION:
- Do not use old nuts after removal; replace with new nuts.
- Do not cause impact to the side air bag (satellite) sensor by dropping etc. Replace the side air bag (satellite) sensor if it has been dropped or sustained an impact.
- Replace both the side air bag (satellite) sensor and front door (satellite) sensor of a deployed SRS
front side air bag and deployed SRS side curtain air bag.

REMOVAL - SIDE AIR BAG (SATELLITE) SENSOR

1.Disconnect the battery negative and positive terminals and wait at least three minutes. Refer to "Removal and Installation" Removal and Replacement.
2.Remove the front seat belt retractor. Refer to "SEAT BELT RETRACTOR : Removal and Installation" Front Seat Belt.
3.Disconnect the side air bag (satellite) sensor harness slide double locking type connector.
4.Remove the nut, then remove side air bag (satellite) sensor.

INSTALLATION - SIDE AIR BAG (SATELLITE) SENSOR

Installation is in the reverse order of removal.

CAUTION:
- Be careful not to damage the side air bag (satellite) sensor harness.
- After the work is completed, make sure no system malfunction is detected by air bag warning lamp.
- In case a malfunction is detected by the air bag warning lamp, reset by the self-diagnosis function and delete the memory by CONSULT.
- If a malfunction is still detected after the above operation, perform self-diagnosis to repair malfunctions. Refer to "SRS Operation Check" SRS Operation Check.

REMOVAL - FRONT DOOR (SATELLITE) SENSOR


WARNING:
- Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
- Do not use air tools or electric tools for servicing.

CAUTION:
- Do not reuse old nuts after removal; replace with new nuts.
- Do not cause impact to the front door (satellite) sensor by dropping etc. Replace the front door (satellite) sensor if it has been dropped or sustained an impact.
- Replace both the side air bag (satellite) sensor and front door (satellite) sensor of a deployed SRS
front side air bag and deployed SRS side curtain air bag.
- Do not hold front door (satellite) sensor by its pressure port. The pressure port must be facing down when handling front door (satellite) sensor.
1.Disconnect the battery negative and positive terminals and wait at least three minutes. Refer to "Removal and Installation" Removal and Replacement.
2.Remove front door finisher and partially remove vapor screen. Refer to "Removal and Installation" Removal And Installation.
3.Disconnect the front door (satellite) sensor harness slide double locking type connector.
4.Remove the nut, then remove front door (satellite) sensor.

INSTALLATION - FRONT DOOR (SATELLITE) SENSOR

Installation is in the reverse order of removal.

CAUTION:
- Be careful not to damage the front door (satellite) sensor harness.
- After the work is completed, make sure no system malfunction is detected by air bag warning lamp.
- In case a malfunction is detected by the air bag warning lamp, reset by the self-diagnosis function and delete the memory by CONSULT.
- If a malfunction is still detected after the above operation, perform self-diagnosis to repair malfunctions. Refer to "SRS Operation Check" SRS Operation Check.