Work Procedure

ADDITIONAL SERVICE WHEN REPLACING TCM

Work Procedure


1. CHECK WORK CONTENTS

Replacing only the TCM-GO TO 2.
Replacing the TCM after the transaxle assembly is replaced-GO TO 2.
Replacing the transaxle assembly after the TCM is replaced-GO TO 4.

2. CHECK AFTER TCM IS REPLACED

1.Shift the selector lever to the P position.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait for a minimum of 20 seconds.
4.Turn ignition switch ON.
5.Check that "P" is displayed on shift position indicator on combination meter.
NOTE:
Displayed approximately 2 seconds after the selector lever is moved to the P position.
Does the shift position indicator display "P"?
YES- WORK END
NO- GO TO 3.

3. DETECT MALFUNCTION ITEMS

Check the following items:
- Harness between the TCM and the ROM assembly inside the transaxle assembly is open or shorted.
- Disconnected, loose, bent, collapsed, or otherwise abnormal connector housing terminals
Is the inspection result normal?
YES- GO TO 2.
NO- Repair or replace the malfunctioning parts.

4. PERFORM TRANSAXLE ASSEMBLY REPLACEMENT

Perform "TRANSAXLE ASSEMBLY REPLACEMENT: Special Repair Requirement".
- Refer to "Work Procedure" Work Procedure.