Shift Interlock: Testing and Inspection

SHIFT LOCK SYSTEM

Component Function Check


1. CHECK SHIFT LOCK OPERATION (BRAKE PEDAL RELEASED)

1.Ignition switch ON.
2.Attempt to shift selector lever to any position other than "P" position with brake pedal released.
Can the selector lever be shifted?
YES- Go to "Diagnosis Procedure" .
NO- GO TO 2.

2. CHECK SHIFT LOCK OPERATION (BRAKE PEDAL APPLIED)

Attempt to shift the selector lever to any position other than "P" position with brake pedal applied.
Can the selector lever be shifted?
YES- Inspection End.
NO- Go to "Diagnosis Procedure" .


Diagnosis Procedure


1. CHECK STOP LAMP SWITCH

1.Ignition switch ON.
2.Check voltage between stop lamp switch connector E13 terminal 4 and ground.





Is the inspection result normal?
YES- GO TO 2.
NO- GO TO 4.

2. CHECK CVT SHIFT SELECTOR

Check voltage between CVT shift selector connector M38 terminal 6 and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 5.

3. CHECK GROUND CIRCUIT

1.Ignition switch OFF.
2.Disconnect CVT shift selector connector.
3.Check continuity between CVT shift selector connector M38 terminal 6 and ground.





Is the inspection result normal?
YES- Replace CVT shift selector. Refer to "Removal and Installation" Removal And Installation.
NO- Repair or replace ground circuit.

4. CHECK STOP LAMP SWITCH POWER CIRCUIT

Check voltage between stop lamp switch connector E13 terminal 3 and ground.





Is the inspection result normal?
YES- Replace stop lamp switch.
NO- Repair or replace power circuit.

5. CHECK CVT SHIFT SELECTOR POWER CIRCUIT

Check voltage between CVT shift selector connector M38 terminal 5 and ground.





Is the inspection result normal?
YES- Replace CVT shift selector. Refer to "Removal and Installation" Removal And Installation.
NO- Repair or replace power circuit.