Disassembly And Assembly

REAR WHEEL HUB

Disassembly and Assembly


DISASSEMBLY






1.Remove sensor rotor, using a suitable tool (A).

CAUTION:
Do not damage the brake drum.





2.Remove snap ring (1).





3.Remove wheel bearing, using the Tool.
Tool number: ST33710000 (-)

ASSEMBLY






1.Install wheel bearing (1) to brake drum (2), using the Tool (A).
Tool number: KV40104730 (-)

CAUTION:
- Do not reuse wheel bearing.
- Do not apply lubricating oil to the press-fit surface of the wheel hub bearing.
- Install wheel bearing with the seal rubber part (B) faced to the brake drum side.
- Set brake drum and wheel bearing horizontally and insert them vertically.
- The press-fit load must be applied to the wheel bearing outer race and the brake drum.
- Do not apply press-fit load to the wheel bearing inner race, the seal (B) on the rubber surface side, and the seal (C) on the metallic surface side. If a press-fit load is applied, the wheel bearing must be replaced with a new one.
- Wheel bearing press-fit load must be 49 kN (5,000 kg-f, 11,015 lb-f).
2.Install snap ring to brake drum.

CAUTION:
- Do not damage the wheel bearing seal.
- The snap ring must be installed evenly into the groove.





3.Install sensor rotor, using the Tool (A).
Tool number: ST30032000 (-)

CAUTION:
Do not reuse sensor rotor.