Removal And Installation

FRONT DOOR GLASS

Removal and Installation


REMOVAL

1.Fully open front door glass.
2.Remove front door finisher. Refer to "Removal and Installation" Removal And Installation.
3.Disconnect door mirror harness connector and remove the clip.
4.Remove front door sealing screen.
NOTE:
Cut the butyl-tape so that some parts of the butyl-tape will remain on the sealing screen, if the sealing screen is reused.
5.Partially remove front door glass run.





6.Operate the main power window or power window and door lock and unlock motor switch to raise or lower the door window until the glass bolts (A) can be seen.
7.Remove the glass bolts.





8.Correctly position the front door glass to pull it out of the sash and remove the door glass from the door.
9.Remove front door outside molding. Refer to "Removal and Installation" .
10.Remove front door glass run.
11.Remove front door lower sash (rear).
- Remove lower sash (rear) bolts.
- Hold the upper part of lower sash and then pull it up to remove.
12.Remove front door lower sash (front).
- Remove lower sash (front) bolt.
- Hold the upper part of lower sash and then pull it up to remove.

INSTALLATION

Installation is in the reverse order of removal.