Operation CHARM: Car repair manuals for everyone.

Automatic Door Lock Function

The Remote Control Door Lock Receiver can be programmed into four different modes. Modes 1 through 3 will "lock" all doors with the ignition "ON," driver's door closed, and the vehicle is taken out of "PARK." If the driver's door is open when the vehicle is taken out of "PARK," the system will not lock the doors until a reset occurs. A reset occurs with vehicle in "PARK" and the Ignition "ON." If the Sliding Door is open when the vehicle is shifted out of "PARK," all vehicle doors will "LOCK" 5 seconds after the Sliding Door is closed. The Sliding Door delay function is cancelled by turning Ignition "OFF"," shifting to "PARK," pressing an "UNLOCK" switch, or by turning the lock cylinder to the "UNLOCK" position. Mode 4 has no Automatic Door Lock Functions.

To Enable Mode 1 (Unlock driver's door when placed in park):
1. Doors Closed.
2. Ignition "ON."
3. Press and hold Drivers Door Lock Switch for 10 seconds (doors will lock, then unlock).
^ If the keyless entry system is not programmed within 10 seconds after the doors lock and unlock the programming is aborted. Programming can also be aborted by turning the ignition "OFF."
4. Press "UNLOCK" button on transmitter once (driver's door will unlock).

To Enable Mode 2 (Unlock all doors when placed in park):
1. Doors closed.
2. Ignition "ON."
3. Press and hold Drivers Door Lock Switch for 10 seconds (doors will lock, then unlock).
^ If the keyless entry system is not programmed within 10 seconds after the doors lock and unlock the programming is aborted. Programming can also be aborted by turning the ignition "OFF."
4. Press "UNLOCK" button on transmitter once (driver's door will unlock).
5. Press "UNLOCK" button on transmitter again (all doors will unlock).

To Enable Mode 3 (No action when placed in park).
1. Doors closed.
2. Ignition "ON."
3. Press and hold Drivers Door Lock Switch for 10 seconds (doors will lock, then unlock).
^ If the keyless entry system is not programmed within 10 seconds after the doors lock and unlock the programming is aborted. Programming can also be aborted by tuning the ignition "OFF."
4. Press "LOCK" button on transmitter once (all doors will lock).

To Enable Mode 4 (No Automatic Door Lock Function):
1. Doors closed.
2. Ignition "ON."
3. Press and hold Drivers Door Lock Switch for 10 seconds (doors will lock, then unlock).
^ If the keyless entry system is not programmed within 10 seconds after the doors lock and unlock the programming is aborted. Programming can also be aborted by turning the ignition "OFF."
4. Press "LOCK" button on transmitter once (all doors will lock).
5. Press "LOCK" button on transmitter again (all doors will lock again).